What We Do
Geothermal Heat Pump Installation Services
We arrange installation, maintenance, repair, and inspection for geothermal heat pump systems.
Geothermal Heat Pump Installation
A site assessment confirms lot size, soil conditions, and your home’s heating and cooling load before any ground loop is designed. The installer then handles horizontal trenching or vertical bore, indoor unit, ductwork integration, and startup commissioning, with every cost itemized separately.
Geothermal Heat Pump Maintenance
Annual checks of loop pressure, propylene glycol concentration, coil condition, and refrigerant charge catch developing faults before they cut off heat mid-season. A maintenance visit also covers air filter replacement, condensate drain line clearing, and thermostat calibration, tasks that protect both the ground loop and the indoor components.
Geothermal Heat Pump Repair
When a geothermal system stops heating or short-cycles, a structured diagnostic traces the fault from thermostat and power supply through refrigerant pressure, circulation pump, and loop integrity. The repair visit identifies the specific failed component, compressor, reversing valve, or control board, before any parts are ordered.
Geothermal System Inspection
Loop pressure, flow rate, antifreeze condition, compressor output, and thermostat controls are each checked and recorded during a full inspection. The findings give you a clear picture of remaining system life and a factual basis for deciding whether repair or replacement makes more sense.
Arrange a Site Assessment & Written Quote
Nothing is dug until you have a written, itemized quote in hand.